What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
08.06.2025 02:13

2024–10–14 [Omar Gharbi Omar Gharbi ]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
At one ohm, the resistor has a maximum of 1 watt power.
How does Bollywood influence Indian culture?
The MOV will conduct when the voltage exceeds 50% of line voltage.
He then describes the function of a fuse.
For this case there are devices called Metal oxide varistors (MOV).
Geomagnetic storm could make northern lights visible in Chicago on Sunday night - Chicago Sun-Times
This is where this question deviates from being a 'generic' question, and becomes more specific.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
What is lightning?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
A circuit breaker is similar, but is resettable.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Watch toddler’s joyful scream when beloved uncle surprises him during hide-and-seek - USA Today
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
but I think this circuit , shows a few more pieces.
These devices are installed between the “hot” and “neutral” and protective ground.
Why would Joseph Smith say that polygamy was God's law?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This is where the MOV conducts again, and dissipated the energy.
10 Habits that are Aging Your Gut, According to Experts - EatingWell
What does a fuse do?
The other is “what does a “fuse” do?”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Are there any Indian wife swapping stories?
Now when you have a certain ac resistance, then a current flows in a loop.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This one hit behind the barn.
PlayStation Plus subscribers react to June free game line-up: 'massive win’ - GAMINGbible
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Phase-resolved attoclock precisely measures electron tunneling time - Phys.org
Here is a simplified AC power diagram.
At least they know the answer if they wanted it.
He then asserts :
Why do people who were very kind and loving once become cold-hearted?
One
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
so, what happens?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
The third is lightning and “how it gets conducted into a home.”
the problem then depends on "how fast does the fuse operate?".
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
The bolt then partially travels down the line to your home.
eight
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
An AC voltage/ current source, and an ac inductive load.
2024–10–10[John johnson John Johnson ]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
But it can get overloaded, and no longer works.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
what exactly is a ‘surge’ protector?
Barnstars:
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
But… the neutral is now “floating” because of the 1 ohm resistance.
These are simplified answers to the original question, and does not change anything I wrote above.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
[old diagram got deleted by accident]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
a photo is worth a thousand words.
I post the exact comment here.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
He then describes Rainy Season and Lightning.
[image of Common-mode choke]
First Sentence:
It also is a device that limits the change in current flow.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Edit 2024–10.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
In schematic diagrams this is the symbol for a fuse:
There are two important concepts here.
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Upvotes:
Because the load is inductive, the current lags the voltage.(by a bit).
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
A fuse is a non-resetable over current circuit protector.
So, the voltage could go up to 500 volts, and the fuse will not open up.
nine
There are three different concepts here that are getting confused.
(Dc diagram shown, AC is similar).
One is “what exactly is in a ‘surge protector’ ? ”
but this device (an Inductor) … impedes the rapid changes in the current.
This device then solves the entire problem.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is 'the assistant's answer'